|
|
bandwidth
kilobits
|
Specifies the bandwidth parameter, in kilobits per second, on an interface. Used by some routing protocols to calculate metrics; has no influence on the actual bandwidth of the data link.
|
|
delay
tens-of-microseconds
|
Specifies the delay parameter, in tens of microseconds, on an interface. Used by some routing protocols to calculate metrics; has no influence on the actual delay of the data link.
|
|
ip address
ip-address mask
[secondary]
|
Specifies the ip address and address mask of an interface.
|
|
maximum-paths
maximum
|
Specifies the maximum number of parallel routes an IP routing protocol can support, from one to six, with a default of four.
|
|
metric holddown
|
Toggles the IGRP holddown on or off.
|
|
metric maximum-hops
hops
|
Specifies the maximum number of hops IGRP can advertise before a route is marked unreachable, with a maximum of 255 and a default of 100.
|
|
metric weights
tos k1 k2 k3 k4 k5
|
Specifies how much weight the bandwidth, load, delay, and reliability parameters should be given in the IGRP and EIGRP metric calculations.
|
|
neighbor
ip-address
|
Defines a unicast address to which a RIP, IGRP, or EGP routing update should be send.
|
|
network
network-number
|
Specifies the network address of one or more directly connected interfaces on which IGRP, EIGRP, or RIP processes should be enabled.
|
|
offset-list {access-list-number | name}{in | out} offset [type number]
|
Specifies a number of hops (for RIP) or additional delay (for IGRP) to be added to the metrics of incoming or outgoing route advertisements.
|
|
passive-interface
type number
|
Disables the transmission of routing updates on an interface.
|
|
router igrp
autonomous-system
|
Enables the indicated IGRP routing process on a router.
|
|
show interface [type number]
|
Displays the configured and monitored characteristics of an interface.
|
|
show ip route [address [mask]][protocol [process-ID]]
|
Displays the current routing table as a whole or by entry.
|
|
timers basic
update invalid holddown flush [sleeptime]
|
Adjusts EGP, RIP, or IGRP process timers.
|
|
traffic-share {balanced | min}
|
Specifies whether an IGRP or EIGRP routing process should use unequal-cost load balancing or equal cost only.
|
|
validate-update-source
|
Toggles the source address validation function of RIP and IGRP routing processes.
|
|
variance
multiplier
|
Specifies a multiplier by which a route metric can vary from the lowest-cost metric and still be included in an unequal-cost load balancing group.
|
